Maxum 2100SC Spécifications télécharger pdf (Page 29)

Chapter 6: Plumbing

Bilge Pump Testing

• The bilge pump is critical to the safety of your boat.

• Check the bilge pump often to make sure it is working.

Test the pump as follows:

1. Turn On the bilge pump switch at

the helm.

2. Any water in the bilge should

pump overboard.

• If the pump motor is running, but

not pumping, inspect the discharge

hose for a kink or collapsed area.

• If no problems are found, check the

bilge pump housing for clogging

debris as follows:

1. Remove the power cartridge:

a. Lift the tab while rotating the

fins counter-clockwise.

b. Lift out the power cartridge.

c. Clear the outer housing of debris.

2. Reinstall the power cartridge:

a. Make sure the “O” ring is properly seated.

b. Coat the “O” ring with a light film of vegetable or mineral oil.

c. Align the cams on either side of the power cartridge with the two slots on the outer housing.

d. Press the power cartridge into the housing while twisting clockwise.

3. Check the reinstallation by trying to twist the fins counter-clockwise without lifting the tab; the cartridge should

stay in place.

OF OIL

“O” RING

TAB FIN

POWER

CARTRIDGE

SLOTCAM

(TYPICAL)

LIGHT FILM

BILGE PUMP COMPONENTS

OUTER

HOUSING

(TYPICAL)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Pas de commentaire

Maxum 2100SC Spécifications Page 29