Maxum 2100SC Spécifications télécharger pdf (Page 44)

Chapter 7: Deck Equipment

2000SR3, & 2200SR3 Bimini Top (If Equipped)

Installing the Bimini Top

1. Slide the swivel ends of the main bow (A) over the aft holes (B) in the side windshield frames and insert the

securing pins.

2. Insert the end eyes of the aft braces (C) into the deck hinges and secure them with the spring loaded

securing pins.

3. Unfold the canvas and slide the swivel ends of the forward braces (D) over the forward holes (E) in the side

windshield frames and insert the securing pins.

4. If the bimini top does not have a smooth, taut look, tighten the top straps (not shown) by adjusting the

strap buckles.

• Since the jaw slides (F) were preset during manufacturing they should not need to be adjusted.

• However, if you think the jaw slides need to be adjusted, obtain the measurements from your selling dealer.

Bow Cover (If Equipped)

1. Snap the two forward snaps to the deck.

2. Snap the bow cover to the entire port side.

3. On the starboard side, only snap the forward half of the bow cover to the deck.

4. Insert the adjustable, center support pole into both the bow cover and the table base.

5. Adjust the support pole so that it is just high enough to stay inserted in the bow cover.

6. Snap the rest of the bow cover to the deck.

7. Adjust the support pole to take any slack out of the bow cover.

END EYE (TYPICAL)

HINGE (TYPICAL)

SPRING LOADED SECURING PIN (TYPICAL)

SECURING PIN

SWIVEL END

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

Pas de commentaire

Maxum 2100SC Spécifications Page 44